Samsung CLP-600 Series, Руководство по обслуживанию

Страница: 100 / 255

Alignment and Adjustmens
Samsung Electronics
Service Manual
6-5
6.2.3 Jam 0 In Tray
If paper is jammed in the paper feed area, a lamp turns on at the corresponding location on the Status
map. If you use the CLP-600N, “Jam0 In Tray1” also appears on the display.
1. Using the handle, completely open the access
door.
2. Carefully remove the paper by pulling in the
direction as shown below. If you cannot find the
jammed paper, or if there is any resistance
removing the paper, stop pulling.
CAUTION:
• Do not touch the green surface, the OPC drum,
on the front of each toner cartridge with your
hands or any other material. Use the handle on
each cartridge in order to avoid touching this
area.
• Be careful not to scratch the surface of the paper
transfer belt.
• If you leave the access door open for more than
a few minutes, the OPC drum can be exposed to
light. This will cause damage to the OPC drum.
Close the access door should the installation
need to be halted for any reason.
3. Pull the tray open. After you pull it all the way out,
lift up the front part of the tray slightly to release
the tray from the printer.
4. Remove the jammed paper by gently pulling it
straight out as shown below.
5. To replace the tray, lower the rear edge, align it
with the slot, and slide it into the printer.
6. After removing the jammed paper, check for
paper which may be jammed in other parts of
the printer.
7. Close the access door firmly. The printer will
resume printing.