35
English
04
Advanced
Featur
es
Notice
The picture may appear corrupted or have static for some
channels when the TV is connected to the Samsung Wireless
LAN Adapter. In such a case, connect the Samsung Wireless
LAN Adapter using a USB cable in a place that is not
affected by radio interference.
Method
Connect via an extension cable
✎
The Samsung Wireless LAN Adapter should be
installed in an interference-free area in order to avoid
interference between the adapter and tuner.
To connect the Samsung Wireless LAN Adapter using an
extension cable, follow these steps:
1.
Connect the extension cable to the USB port.
2.
Connect the extension cable and Samsung Wireless
LAN Adapter.
3.
Attach the Samsung Wireless LAN Adapter to the back
of the TV near the top, using double-sided adhesive
tape.
Network Setup (Samsung Auto
Configuration)
The Samsung Auto Configuration function lets you connect
your Samsung TV automatically to non-Samsung wireless
APs. If your non-Samsung AP does not support Samsung
Auto Configuraton, you must connect using one of the
other methods:
PBC (WPS)
, auto configuration, or manual
configuration.
✎
To use this function, you must set
SWL(Samsung
Wireless Link)
to
Off
in the TV’s on-screen menu.
✎
You can check for equipment that supports Samsung
Auto Configuration on www.samsung.com.
How to set up using Samsung Auto Configuration
1.
Place the AP and TV next to each other and turn them
on.
✎
Because AP booting times vary, you may have
to wait approximately two minutes for your AP to
boot up.
✎
Ensure the LAN cable is connected to the
WAN port of the AP during Samsung Auto
Configuration. If it is not connected, Samsung
Auto Configuration only confirms that the TV is
connected to the AP, but does not confirm it is
connected to the Internet.
2.
After 2 minutes, connect the Samsung Wireless LAN
Adapter to the TV. When the Samsung Wireless LAN
Adapter establishes a connection with your TV, a pop-up
window appears.
3.
As soon as a connection is established, place the AP
parallel to the Samsung Wireless LAN Adapter and not
farther than than 9 and 7/8s inches (25cm) from it.
4.
Wait until the connection is automatically established.
✎
If Samsung Auto Configuration does not connect
your TV to your AP, a pop-up window appears on
the screen notifying you of the failure. If you want
to try using Samsung Auto Configuration again,
reset the AP, disconnect the Samsung Wireless
LAN Adapter and then try again from Step 1. You
can also choose one of the other connection
setup methods: PBC (WPS), auto, or manual.
5.
Place the AP in a desired location.
✎
If the AP settings change or you install a new
AP, you must perform the Samsung Auto
Configuration procedure again, beginning from
Step 1.
or
[UC9000_NA]BN68-03088A-01L03.indb 35
2010-06-29 오전 10:33:11
Содержание BN68-03088A-01
Страница 69: ...This page is intentionally left blank UC9000_NA BN68 03088A 01L03 indb 69 2010 06 29 오전 10 33 29 ...
Страница 137: ...This page is intentionally left blank UC9000_NA BN68 03088A 01L03 indb 69 2010 06 29 오전 10 34 05 ...
Страница 205: ...This page is intentionally left blank UC9000_NA BN68 03088A 01L03 indb 69 2010 06 29 오전 10 34 42 ...