Samsung AVXCSH022EE, Руководство по обслуживанию

Страница: 114 / 508

Troubleshooting
Samsung Electronics 4-23
: On : Flickering : Off
- When stopping the operation during an error is displayed, all lamps are off.
- When restarting after stopping an operation, redisplay the error status by deciding the error again on Normal Operation.
- Refer to the “4. Troubleshooting” for detail contents related to the error mode.
■
LED lamp display with error detection (cont.)
Follow-up measures Causes
LED lamp display
Error type
Self diagnosis error display
(Include the indoor unit that is not
detected)
1 1. EEV close status defect
1 2. EEV open status defect
1 3. EVAP OUT sensor breakaway
1 4. EVAP IN sensor breakaway
1 5. COND MID sensor breakaway
1 6. Refrigerant complete leakage 2
nd
detection
1 7. COND high temperature 2
nd
detection
1 8. DISCHARGE high temperature 2
nd
detection
1 9. Low pressure switch 2
nd
detection
COMP DOWN
10. Reverse phase detection error
11. Freezing 6
th
detection compressor
stop
12. Compression sensor self diagnosis
(G8, G9)
13. Compressor down error by
compression ratio control
Flot switch detection
Peripheral control device option setting
error
EEPROM error
EEPROM option error
Outdoor Unit Operational
error
Overflow of condensed
water of indoor unit drain
plate
Setting error of the indoor
unit option device
Incorrectly input the indoor
unit option code
Not input the indoor unit
option code
Check error on the Outdoor
Unit display window then
take appropriate steps.
t$IFDLUIFESBJOQJQF
pump
t$IFDLUIFESBJOQJQF
clogging
Readjust the indoor PCB
option S/W
Input the indoor unit option
code
Input the indoor unit option
code
$9;&6+B$BaLQGG