Cutting/Flaring the Pipes
E-
11
ENGLISH
Outer Diameter
Torque (kgf•cm)
6.35 mm (1/4")
144~176
9.52 mm (3/8")
333~407
12.70 mm (1/2")
504~616
15.88 mm (5/8")
630~770
19.05 mm (3/4")
990~1210
22.23 mm (7/8")
990~1210
Make sure that you have the required tools available (pipe cutter, reamer,
flaring tool and pipe holder).
1
If you wish to shorten the pipes, cut it with a pipe cutter, taking care to ensure
that the cut edge remains at a 90° angle with the side of the pipe. Refer to the
illustrations below for examples of edges cut correctly and incorrectly.
2
To prevent any gas from leaking out, remove all burrs at the cut edge of the
pipe, using a reamer.
3
Slide a flare nut on to the pipe and modify the flare.
4
Check that the flaring is correct, referring to the illustrations below for
examples of incorrect flaring.
5
Align the pipes and tighten the flare nuts first manually and then with
a wrench, applying the following torque.
6
Outer Diameter (D)
Depth (A)
6.35 mm (1/4")
1.3mm
9.52 mm (3/8")
1.8mm
12.70 mm (1/2")
2.0mm
15.88 mm (5/8")
2.2mm
19.05 mm (3/4")
2.2mm
22.23 mm (7/8")
2.2mm
90
O
Oblique
Rough
Burr
Inclined
Damaged Surface
Cracked
Uneven Thickness
◆
C
C
C
C
A
A
A
A
U
U
U
U
T
T
T
T
II
II
O
O
O
O
N
N
N
N
In case of welding the pipe, you must weld with nitrogen
gas blowing.