Samsung ASH-0906ER, Руководство по обслуживанию, Страница: 12 / 54

Samsung Electronics
3-7
Operating Instructions and Installation
3-2-2(c) Piping and drain hose installation
3-2-2(d) Indoor unit installation
1. Fix the drain hose under the refrigerant piping.
2. Be careful not to allow slack of the drain hose.
3. Do not allow the piping to jut out from the back of the indoor
unit.
4. Insulate both of the refrigerant pipes so that dewing and other
problems do not occur.
5. Be careful in bending the pipes. The bending radius must be
100mm or larger.
Ditch
Drain hose
Shield
Extension drain hose
5cm less
DRAINAGE
1. Run the drain hose sloped downward.
2. Do not install the drain hose as illustrated below.
3. Put water in the drain pan and make sure that the water is
drained outdoor.
4. When connecting extension drain hose. insulate the inside
part of extension drain hose with shield.
Set the drain hose in the inner part of the
indoor unit and the assembly cable in
lower part of it. Wind tape round them.
Right-hand connection with piping Left-hand connection with piping Under-side connection with piping
1. Open the rear left Bush-Body.
1. Open the rear right Bush-
Body.
2. Cut out the Holder-pipe slit
part.
3. Support the above section to
be bent with your hand and
bend the pipes there.
1. Cut out the knock-out piece from the
under side of the rear body with a
knife, etc. Smooth the cut edges.
2. Cut out the holder pipe on its slit part.
①
②
③
Assembly
piping
Bush-Body
of the rear body Bush-Body
of the rear body
Holder pipe
Installation
plate
Assembly Cable
Piping
Drain hose
1. To fix the pipe of the indoor unit with the fixing screw, utilize the pipe holder plate as illustrated in
the figure.
2. Pass the pipes through the hole in the wall, and hook the indoor unit to the installation plate.
3. Move the indoor unit to the right and left to make sure that the unit is securely hooked on to the
installation plate.
2
1
3
Hook here
Piping
Tape
Assembly cable
Drain hose
Pipe holder plate