Samsung AS-2408BR, Руководство по обслуживанию, Страница: 13 / 55

Operating Instructions and Installation
3-7
Samsung Electronics
3-2-2(c) Piping and drain hose installation
1 . Fix the drain hose right the refrigerant piping.
2. Be careful not to form a slack of the drain hose.
3. Do not allow the piping to jut out from the back of the indoor unit.
4. Insulate both of the refrigerant pipings so that dewing and troubles
may not happen.
5. Be careful in bending the pipes. The bending radius must be
100mm or larg e r.
A.Right-hand connection with piping C.Under-side connection with piping B.Left-hand connection with piping
1. Cut out the knock-out piece from the
rightside of the rear body with a knife,
etc. Smooth the cut edges.
2. Cut out the Holder-pipe slit part.
3. Support the above section to be bent
with your hand and bend the pipes
there.
1. Cut out the knock-out piece from the
leftside of the rear body with a knife,
etc. Smooth the cut edges.
1. Cut out the knock-out piece from the
underside of the rear body with a knife,
etc. Smooth the cut edges.
2. Cut out the Holder-pipe on its slit part.
Set the drain hose in the inner part of the
indoor unit and the assembly cable in lower part of it.
Wind tape round them.
Piping
Assembly cable
Drain hose
Tape
Piping
B
C
A
Assembly cable
Installation plate
Drain hose
3-2-2(b) Wiring connection(Indoor unit)
1. Open the Grille and remove the
screw securing the cover.
2. AS-18**: Pass the assembly cable
through the rear of the indoor
unit and connect the assembly
cable to terminals 1~3.
*Each wire is labelled with the
corresponding terminal number.
AS-24**: Firmly connet the cable
connector with connector.(6pin,
4-cable)
3. Assembly every parts by contrary
order to disassembly.
Screw
Indoor
unit
Conneitor
AS-18**
AS-24**
Outdoor
unit