Samson AirLine Micro Earset, Руководство пользователя

Страница: 10 / 20

10
3. Remove the USB cable and continue with setup.
4. Physically place the receiver where it will be used (if desired, the AR2 receiver model can be used with the included
AR2D dock) and fully extend the antennas vertically.
5. Turn your audio system off and connect the receiver’s 1/8” unbalanced output jack to the microphone or line level audio
input of your amplifier or mixer. Set the AR2 Mic/Line Level switch to match the input.
6. Turn on the receiver using the Power Switch. When on, the Status Indicator will be steady YELLOW.
7. Turn on your AH2 transmitter by pressing and holding the Multi-Function Switch, until the Status Indicator LED flashes
GREEN, then release it. The AH2 Status Indicator will now light steady GREEN. The AR2 receiver Status Indicator will
change from YELLOW to GREEN indicating that it is receiving a valid RF signal.
8. Position the AH2 on your head, as illustrated on page 7.
9. Turn on your connected amplifier and/or mixer, but keep its volume all the way down. Make sure the AH2 transmitter is not
muted.
Note: If the AH2 is muted, the AH2 Status Indicator LED will flash GREEN and the AR2 Status Indicator will flash GREEN.
To unmute the AH2, press the Multi-Function Switch and the Status Indicator will light steady GREEN.
10. Speak or sing into the earset microphone at a normal performance level while slowly raising the audio input control of your
amplifier or mixer, until the desired volume is reached.
Quick Start