Samson 5857, Монтаж и эксплуатация, Страница: 40 / 80

8-8 EB 5857 EN
Operation
8.4.1 Copying function
The memory pen can be used to copy setting data to other Types 5857 Actuators after the
data from the actuator have been transferred to the memory pen.
'Automatically write to memory pen' is automatically reset to the read status after data are
transferred from the actuator for the first time.
8.4.2 Data logging
The memory pen-64 allows the following data to be saved:
− Input in %
− Actuator travel in %
− Position feedback in %
− Temperature inside device in °C
−
Torque switch: Actuator stem retracted
− Torque switch: Actuator stem extended
− Position feedback is relative
− Malfunctions
− Input signal failure
− Direction of action switch
− Initialization key
The data are logged until the memory capacity of the memory pen is full.
Data in the memory pen can be saved to a data logging file using the TROVIS-VIEW soft -
ware.
Data logging
Î
See section 8.4 for the blinking pattern.
1. Plug the memory pen into the serial interface of the actuator (Fig. 8-3).
The yellow LED on the actuator indicates that the data logging is being prepared.
A change in the blinking pattern of the yellow LED indicates that data are being saved to
the memory pen.
Note