Samson 33-7, Монтаж и эксплуатация

Страница: 41 / 58

EB 2551-2 EN 9-1
Servicing
9 Servicing
The regulator does not require any
maintenance. Nevertheless, it is subject to
natural wear, particularly at the seat, plug
and operating diaphragm. Depending on
the operating conditions, check the regulator
at regular intervals to avoid possible
malfunctions. Plant operators are responsible
for drawing up an inspection and test plan.
Details on faults and how to remedy them
can be found in the 'Malfunctions' section.
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
We recommend removing the regulator from
the pipeline before performing any mainte-
nance or service work.
Risk of burn injuries due to hot or cold com-
ponents and pipeline.
Regulator components and the pipeline may
become very hot or cold. Risk of burn inju-
ries.
Î
Allow components and pipelines to cool
down or warm up to the ambient tem-
perature.
Î
Wear protective clothing and safety
gloves.
Risk of personal injury due to residual
process medium in the regulator.
While working on the regulator, residual
WARNING !
WARNING ! WARNING !
process medium can escape and, depending
on its properties, may lead to personal in-
jury, e.g. (chemical) burns.
Î
Wear protective clothing, safety gloves
and eye protection.
Risk of TÜV approval (based on AGFW
worksheet FW 504) becoming void.
Î
Consult SAMSON's After-sales Service
before you change parts or perform
service or repair work on TÜV-tested
Type 33-7 Regulators.
Risk of regulator damage due to the use of
unsuitable tools.
Î
Only use tools approved by SAMSON
(see 'Tools' in Annex).
Risk of regulator damage due to exces-
sively high or low tightening torques.
Observe the specified torques when tighten -
ing regulator components. Excessive tighten -
NOTICE
!
NOTICE
!
NOTICE
!