Samson 2780-1, Монтаж и эксплуатация, Страница: 19 / 52

EB 5840 EN 4-1
Shipment and on-site transport
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel qualified for the
assignment accordingly.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol‑
lows:
1. Check the scope of delivery. Check that
the specifications on the actuator name‑
plate match the specifications in the de‑
livery note. See 'Markings on the device'
section for nameplate details.
2. Check the shipment for transportation
damage. Report any damage to
SAMSON and the forwarding agent
(refer to delivery note).
3. Determine the weight and dimensions of
the units to be lifted and transported in
order to select the appropriate lifting
equipment and lifting accessories. Refer
to the transport documents and 'Techni‑
cal data' section.
4.2 Removing the packaging
from the actuator
Observe the following sequence:
Î
Do not open or remove the packaging
until immediately before mounting the
actuator.
Î
Dispose and recycle the packaging in ac‑
cordance with the local regulations.
4.3 Transporting and lifting the
actuator
Risk due to suspended loads falling.
Î
Stay clear of suspended or moving
loads.
Î
Close off and secure the transport paths.
Risk of lifting equipment tipping over and
risk of damage to lifting accessories due to
exceeding the rated lifting capacity.
Î
Only use approved lifting equipment and
accessories whose minimum lifting ca‑
pacity is higher than the weight of the
actuator (including the packaging, if ap‑
plicable).
Our after‑sales service can provide more
detailed transport and lifting instructions on
request.
4.3.1 Transporting the actu-
ator
Î
Leave the actuator in its packaging to
transport it.
Î
Observe the transport instructions.
Transport instructions
−
Protect the actuator against external in‑
fluences (e.g. impact).
DANGER !
WARNING !
Tip