REV.
07 - 01/2022 - Cod. 150089
www.larius.com
55
VEGA 34:1
K
K1
K2
Fig. 1K
K3
Fig. 2K
K4
•
Disassemble and clean the high pressure filter for product
output (
K4
).
Fig.3K
IT
EN
• Periodically check
(and in any case each time the pump is
started after a long period of downtime)
that the gaskets
ring nut is tight in order to avoid any product leak.
• Weekly check that the gaskets ring nut (
K1
) is tight. To
tighten the gaskets ring nut (
K1
) use the provided wrench
(
K2
). The ring nut shall be duly tightened so that to prevent
any leak but this shall not be excessive in order to avoid the
blocking of the pumping piston and the wear of the sealing
gaskets. Should the product leak, provide to replace the
upper gaskets. This adjustment shall be carried out after
having removed the air feeding tube and having discharged
the pressure.
Periodically check the air supply line to the pump.
Make sure that the air is always clean and lubricated.
before carrying out any control or maintenance
operation on the pump, always close the compressed
air supply and discharge the pressure in the circuit.
MANUTENZIONE ORDINARIA
K.1 LUbRICATING THE GASKETS RING NUT
Daily check that the ring nut is covered with hydraulic oil (
rif. 16325)
; the oil improves the sliding of the piston and prevent
the product, coming out from sealing gaskets, to dry once the equipment is stopped.
OIL
Rif. 16325
•
Disassemble and clean the product suction filter
(
K3
).
K.2 CLEANING THE SUCTION FILTER
K.3 CLEANING THE PRODUCT SUCTION FILTER
Содержание LARIUS VEGA 34:1
Страница 22: ...P a g i n a l a s c i a t a i n t e n z i o n a l m e n t e v u o t a...
Страница 40: ...REV 07 01 2022 Cod 150089 www larius com 40 VEGA 34 1 IT IT...
Страница 62: ...I n t e n t i o n a l l y b l a n k p a g e...
Страница 80: ...REV 07 01 2022 Cod 150089 www larius com 80 VEGA 34 1 IT EN...
