www.larius.com
17
MIRO’ LINER PLUS
ED. 05 - 08/2020 - Cod. 150162
PAINTING OPERATIONES
After having performed all of the operations in the
“OPERATION”
chapter, work may be started using the following controls:
•
Slowly turn clockwise the pressure control knob
(I1
) to reach
the pressure value in order to ensure a good atomization of
the product.
I
I2
NEVER point the spray gun at yourselves or at
other people. The contact with the casting can
cause serious injuries. In case of injuries caused
by the gun casting, seek immediate medical advice
specifying the type of the product injected.
•
An irregular and marked spray on the sides indicates a low
working pressure. On the contrary, a too high pressure
causes a high fog
(“overspray”)
and waste of product.
• Pull the lever on the right
(
I2
) to activate the spray gun and
begin working, advancing the machine in a continuous manner.
Recirculating-safety valve: when working at the
maximum pressure available, releasing the gun
trigger sudden increases of pressure can occur.
In this case, the recirculating-safety valve opens
automatically eliminating part of the product from
the recirculating tube.
Then it closes so as to go back to the first working
conditions.
J1
J3
• Release the residual pressure by holding down the trigger
of the gun and pointing it into a container.
• Eliminate the paint remaining within the tank (
J2
) by placing
the re-circulation tube (
J3
) into a container.
•
Open the recirculating-safety valve (
J4
).
J
CLEANING AT THE END OF WORK
• Reduce pressure to the minimum
(turn counterclockwise the
pressure control knob (
J1
) ).
J3
J2
J4
I1
+
-
