GETTING STARTED:
>>>Step One:
Fully charging the smart watch. It will take 2 hours.
>>>Step Two:
Insert a valid
Nano SIM Card
into the SIM card slot.
Do NOT try to insert a Micro SIM Card.
NOTE
: When you are going to insert in a
Nano
SIM card, make sure the smart watch is Power OFF. Or else it will need you to
restart the smart watch after the
Nano
SIM card has been inserted in.
Make sure the Nano SIM card,
***a valid
Nano
SIM card;
***must applied the Mobile Internet Data service, which is provided by the Telecom provider;
***must applied the incoming phone call number displaying service, which is provided by the Telecom provider.
How to insert the Nano SIM card into the SIM card slot?
Firstly, there is a small screwdriver provided in the gift box, use the small screwdriver to take off the screw from the shell of SIM
Card Slot.
Secondly, take off the shell, and then insert the
Nano
SIM card into the SIM card slot. Follow below sketch.
You can hear a tiny sound once the
Nano
SIM card has been inserted into the SIM card slot and into the right position.
To take the
Nano
SIM card out from the card slot, push it in towards inside, to let the
Nano
SIM card bounce off the slot.
Do not throw away the Black Elastic when you open the Card slot shell. The smart watch won't be splashproof anymore, if you
throw away the black elastic.
This product communication is on 2G data system. The 2G network must be available in your country. The SIM "PIN" must be
deactivated before inserting in the smartwatch.
>>>Step Three: D
ownload and to install the
SeTracker2.
(Do NOT download the SeTracker). If you have Android use Play Store
and if have IOS system, use the APP STORE.
Install the SeTracker2 on your Android smart phone or iPhone.
Always tap OK/Yes/Confirm/Accept/Allow for any pop-up requests.
NOTE: The APK/APP should be SeTracker2. Do not mistake to use SeTracker.
>>>Step Four:
At your smart phone, run the SeTracker2, register a new account and use the new account to log on the
SeTracker2. Before log on the SeTracker2, the Area must select Europe and Africa. It will be displayed on the Log on interface
