Sames Inocart NDT, Инструкция по эксплуатации

Страница: 9 / 36

9 Member of Exel group
DRT7161
B - 2023/10
1.4. Simplified analysis of potential ignition sources according to EN 80079-36
1.5. Precautions for Use
This document contains information that all operators should be aware of and understand before using the carts
Inocart . This information highlights situations that could result in serious damage and indicates the precautions that
should be taken to avoid them.
Before any use of the Inobox control module, check that all operators:
• have previously be trained by the company Sames , or by their distributors registered by them for this
purpose.
• have read and understood the user manual and all rules for installation and operation, as laid out
below.
It is the responsibility of the operators’ workshop manager to ensure these two points and it is also his
responsibility to make sure that all operators have read and understood the user
manuals for any peripheral electrical equipment present in the powdering area.
1.6. Warnings
It is imperative that anyone wearing a pacemaker does not use the equipment and does not
enter the projection area.
High voltage can cause the pacemaker to malfunction.
This equipment may be hazardous if it is not used, disassembled and reassembled in
accordance with the rules indicated in this manual and in any applicable European Standard or
national safety regulations.
This equipment is intended for spraying powder paint only.
Risk of ignition
Measures applied to prevent the source of
ignition from becoming effective
Potential source of
ignition Description / Main cause (What are the conditions
causing the risk of ignition)
Description of the measure applied
Hot surface Vibrator heating in vibrating table version
Maximum vibrator surface temperature of
100°C
Static electricity
Internal electrostatic discharge in powder hose Antistatic hose
Electrostatic discharge on the cart Equipotentiality of the metal parts + earthing
Electrostatic discharge on the pressure tank Equipotentiality of the metal parts + earthing