Index revision : A
25
7140
4.7. Counterweight adjustment
For a good working of the equipment, it is advisable that the weight of the carriage, equipped
with the cables and hoses of the projectors, is substantially balanced by the weight of the coun-
terweights equipped with its ballasts. This balance is achieved by adding or removing weights
that are accessible after removing the side panels of the
Inorecip V
.
Each ballast weighs approximately 1.8 kg. Tighten the 4 fixing nuts (M8) by counterweights after
changing the ballast.
4.8. Antistatic toothed belt tension adjustment
For correct operation of the equipment, it is
recommended that the antistatic toothed belt
on the carriage be correctly tensioned and alig-
ned.
• Remove the side panel.
• Move the carriage down to the lower stop
• Loosen the locking screw (
A
).
• Tighten the belt by tightening the 2 screws
(
C
).
• Apply a force
F
= 50 N on the belt and
control the tension distance according to
the table below:
• Tighten the locking screw (
A
).
• Reassemble the side panel.
Number of projector
Number of ballasts
2
4
4
8
6
10
8
16
10
20
12
22
Stroke
(mm)
Distance
between
pulleys (L)
(mm)
Tension
distance (F)
(mm)
1200
2196
28
1500 2496
31,2
1800
2796
34,9
2100
3096
38,7
2400
3396
42,5
2700
3696
46,2
DES07933
(
A
)
(
C
)
(
B
)
