Samba MT, Руководство пользователя

Страница: 8 / 11

11) Finally, cut one length of 2-conductor speaker wire approximately 6"-8" in length, and label
the length of wire "Input".
Final Assembly:
12) Insert crossover through woofer hole and glue crossover to the bottom of the enclosure
(polyurethane glue, high temperature hot glue gun, or epoxy is recommended). Ensure all
crossover components are securely held in place to prevent rattles.
13) Install port tubes in the back panel. Depending on port length, the tuning frequency will be
between 40-45 Hz. The longer the port, the lower the tuning frequency.
14)
Install the rear binding posts and connect the input wires from the crossover while
observing polarity (positive = red, negative = black)
15) Connect tweeter wires to tweeter terminals while observing polarity (the positive terminal
is marked with red marker).
16) Connect woofer wires to woofer terminals while observing polarity. Set woofer in place.
Using a screwdriver, secure woofer with screws just until tight being careful not to strip out
the holes (a power drill is not recommended).
You are now ready to enjoy your finished speakers!