SaMASZ KDT 220, Руководство оператора

Страница: 23 / 52

23
OPERATOR’S MANUAL REAR DISC MOWER KDT
WARNING!
Handle all parts with utmost care. Never place your hands or fingers between
one part and the other. Wear safety clothes such as gloves, protective footwear
and goggles. The operation of shortening must be carried out with the utmost
care as the PTO shaft will have to be replaced if the telescopic shafts are
shortened to an excessive extent.
WARNING!
The PTO shaft should be mounted only during operation time and disconnected
from tractor PTO for transport and service.
WARNING!
The manufacturer declines all liability for damage caused by an incorrectly fitted
or used PTO shaft.
WARNING!
Use the machines with PTO shafts designed to drive them. Before the work
begins, check the safety guards (in tractor, mower and PTO shaft), if they are
placed correctly and are not damaged. Damaged or lost parts must be replaced
with genuine ones. Make sure the PTO shaft is properly mounted. It is forbidden
to approach the rotating parts, because it may lead to serious injuries or even
death. All service and repair operations must be done only after the tractor
engine has been stopped and ignition key off, all rotating parts have come to
the complete standstill and the cutterbar is on the ground. Before the operation
begins, read operator’s manuals of both the machine and PTO shaft.
5.3. Preparing the mower for transport
To prepare the mower for transport and to meet safety precautions, please do the following:
❑
lift the mower with tractor hydraulic lift until the lower lift pins of the mower 3-point linkage frame
raise about 1' 8'' above the ground (
Fig. 13 ),
❑
lift support leg up and secure it with split cotter,
❑
remove the pin 1 and put it into the bush 2 ( Fig. 10 ),
❑
lift the cutterbar by hydraulic cylinder vertically until the pawl G locks in ( Fig. 10 ),
❑
secure the cutterbar against falling by the shut-off valve ( Fig. 12) placed on the mower’s hydraulic
cylinder.
WARNING!
During transport the shut-off valve of mower hydraulic lift should always be
closed
– the valve lever in Z position ( Fig. 12 ). It protects the mower against
incidental falling in case of hydraulic failure.