Sam4s NR-500R, Руководство по обслуживанию

Страница: 30 / 102

3 Installation and Operation
3-12 SAM4S NR-500 SERIES
3-3 F. Flash ROM Updated by SD
The NR-500 Series Flash ROM program is contained in a binary file. This file contains both the Boot
program area and the Application program area.
1. Copy binary file to the root of the SD card. : SD:/update/
2. Insert the SD card into the register. (The SD slot is located inside the printer compartment. Remove
the security screw and open the flap securing the SD slot. Insert the SD card until you hear a click sound
and the SD card is locked in.)
Boot Area Update
3. At the NR-500 Series, move to the SERVICE MODE .
4. Press the
ȡ
key and the
ȣ
key to select menu and press the CASH key to confirm. Select the
7.PROGRAM BACKUP menu.
5. Select the 1.SD menu.
6. Select the 6.BOOT UP SD menu.
7. After a short pause, the register will display confirmation of the successful download with the message
“DOWNLOAD 100 % FINISHED! !.
8. Turn the ECR power switch OFF/ON and proceed directly to the next step: Application Update.
Program Area Update
9. Set the SERVICE MODE .
10. Press the upper right key and the lower right key. A rapid beep-beep-beep sound will be heard. Release
the upper right key and the lower right key.
11. Press the
ȡ
key and the
ȣ
key to select menu and press the CASH key to confirm. Select the 2.SD
CARD menu.
12. The display will flash (Current program is being erased), after a few seconds, the display will continue to
flash, but at a slower rate. This continues for about 1-minute while the new program is being loaded.
When the load is complete, a rapid beep-beep-beep sound will be heard again the display will stop
flashing and display a blue color to confirm update completion.
13. Power the register OFF . The FLASH ROM update is complete.
14. Remove the SD card from the register.
15. Perform a memory all clear on the ECR. The ECR is now ready to program or to load a previously
saved end-user program.
3-3 G. Flash ROM Updated by PC
Update Files
To complete the firmware update, you will be supplied with the following files:
x
DownLoad.exe (The update utility program)
x
Binary file
PC Connection Cable
YOU MUST USE Port #1. Use the following cable:
x
Part # 522120 (Register DB-9MF COM 1 to PC DB-9F)
Boot Area Update
1. Connect the Serial Cable From ECR to PC.
2. At the register, move to the SERVICE MODE .