EN
43
ASSEMBLY OF PRODUCT
--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Parts inside the appli
-
ance may have sharp
edges. Use protective
gloves (Fig. 12).
CAUTION!
The furniture that
the appliance will be
mounted on should
be resistant to 90°C temperature.
The durability of the furniture that will be
mounted on should also be ensured after
the cutting operations have been completed.
Particularly in thin plates the carrying capacity
and durability should be provided with suitable
support parts. Consider the weight of the
appliance by including additional loads. The
reinforcing material used should be heat and
moisture resistant. The weight of the appliance
is specified in the label on the package.
Clean the sawdust after cutting. Cover the
cut surfaces so that they are heat resistant
and waterproof.
The cross-sectional surface angle to the work
-
ing plate should be 90°.
MEASURES OF THE EXTRACTION HOOD
Remove the body cover before installing the
appliance. Remove the appliance package.
1. Press on the label on the appliance, open
the lighting and filter group (Fig. 13). Pull
the lighting and filter group upwards and
remove it (Fig. 13).
2. Prepare the mount surface in align with the
dimensions specified in the technical
illustration (Fig. 14). Observe the warnings
regarding preparing the kitchen counter
(Fig. 14).
3. Prepare the mount surface for the motor
box in align with the dimensions specified in
the technical illustration (Fig. 15). Observe
the warnings regarding preparing the
kitchen counter (Fig. 15).
4. Place the cooker to the kitchen counter that
was prepared prior (Fig. 16).
5. Place the exterior container of the hood
to the mounting plates behind the lower
section of the cooker and tighten 2 screws
to attach them (Fig. 17).
Fig. 12
Fig. 13
Fig. 14
250
280
35,5
295
155
60
Ø70
105
99
Fig. 15
Fig. 16
Fig. 17
