SALVIMAR MANTA 100, Руководство пользователя

Страница: 9 / 16

9 SALVIMAR 2020/21
USER MANUAL MANTA 100 INFLATABLE DIVE BOARD
PUMP
Your MANTA 100 Dive Board comes with a high-pressure pump. This pressure
pump, pumps low volume of air with each pumping motion. It takes quite
longer to fill the
MANTA 100 Dive Board with air, but allows the board to
reach a higher air pressure. This is good for achieving maximum performance
from the
MANTA 100 Dive Board.
Assemble the pump by twisting the corrugated hose under the pressure
gauge.
If the pump begins to squeak or become stiff please lubricate the pump.
To lubricate the pump, simply open the top unscrewing the threated plastic
ring and place a few drops of oil/grease on the gasket and tube.
Please clean the air filter periodically, also located inside the top of the pump.
BOARD INFLATION
Remove the
MANTA 100
Dive Board from the box onto a level and smooth
surface.
Unfold the board until it is laying flat with top side facing up.
Attach the corrugated pump hose to the main pump twisting slightly in a
clockwise motion.
Attach the corrugated pump hose to the air valve with a clockwise half twist
motion.
Push- Push Dual function
Button Out “Double”: Start with double action for high volume
Button In “Single”: Finish with single action for high pressure
Begin pumping air into the board by sliding the pump handle up and down.
Try to maintain proper posture and leverage while you pump.
Continue to inflate the
MANTA 100
dive board until you reach the
recommended 13-15psi. (Bar 0,90 – 1,035)
Warning : Do not use an air compressor
Maximum Air pressure for this product : 15psi.
(Bar 1,035)
Do not exceed this, overinflating this board could damage the MANTA 100
Dive board and void your warranty.
Remove the pump with a counter-clockwise half twist motion
The air pressure in the board can vary over time and depends on
temperature.
If there is a small decrease of pressure over a number of days, please pump the
board up slightly until you reach the recommended psi/bar.
Do not pump the board to a high pressure and leave it exposed in the hot sun.
Deflate the board slightly and check the pressure of the board.
The heat from the sun should increase the pressure of the board.