Salus Gothenburg II, Руководство пользователя

Страница: 30 / 48

30
17MM Wrench
tighten. Be sure not to over tighten. In additional, you will need to check the tightness of the
stainless steel bands every 6-12 months. See figure 10.
figure 10 Attention: The joint position of the stainless steel band should be near
the top and to the inside of the support cradles.
Be sure to inspect the tightness of the stainless steel bands every 4-6 months to minimize small gaps.
If the stainless steel bands become loose, use the 17mm wrench to tighten.
11. Install Bench Supports
Start with the left side. Use a Phillips screwdriver (power screwdriver will save time) to
screw the five pieces of M4*40 screws into the lower bench back wood plank in order to
mount to the wall. The back wood plank needs to be level with the wood planks on the
front and rear panels. Use a leveler to make sure the lower bench back wood plank is
horizontally straight before screwing into place. See figure 11 & 11a. Do the same for the
right side.
Screws
figure 11
M4*40=5pcs each side
Stainless Steel