Salus CO10RF Скачать руководство пользователя страница 2

INSTALLATION

Product Compliance & Safety Info

Product Compliance 

• Electro-Magnetic Compatibility directive

2004 / 108 / EC

• Low voltage Directive 2006/95/EC

Warning

These instructions are applicable to
the SALUS model stated on this
instruction guide.

This product must be fitted by a competent
person, and installation must comply with the
guidance, standards and regulations applicable
to the city, country or state where the product is
installed. Failure to comply with the
requirements of the relevant guidance,
standards and regulations could lead to injury,
death or prosecution. 

Warning

Always isolate the AC Mains supply before
installing or working on any components that
require 230 VAC 50Hz supply.

We hope you enjoy this product...

Box Contents

I N S TA L L E R   /   U S E R   M A N U A L

Zigbee Coordinator

Models: CO10RF

1 x Installer / User manual

1 x CO10RF

1 x USB Adapter

1 x UK Plug + EU Plug Adapter

Switch the 230V mains outlet on and
ensure the button is illuminated (red)
as shown above.

Attach plug adapter to the USB adapter

Attach Coordinator to USB adaptor. 

INSTALLATION

SYSTEM OVERVIEW

To commence system installation press and
hold the button until for 5 seconds or the
button starts flashing red. This means the
Zigbee network is ready to accept iT600
devices.

When everything is paired press and hold
button for 5 seconds or flashing stops.

Please refer to individual 
device manuals.

UK or EU plug version

SALUS Wiring Centre KL10RF

RX10RF

TRV10RF

VS10/20RF Thermostat

CO10RF

INTRODUCTION

Thank for purchasing the SALUS CO10RF Zigbee
coordinator. The Zigbee coordinator controls the
Zigbee communication of your iT600 system.

CHECKING SYSTEM CONFIGURATION

Please refer to individual device
manuals for more information.

The Zigbee coordinator must be used with
the iT600 RF range of products below:

Press again for 1 second

to cancel identify.

Identify mode will time

out after 10 minutes.

To check that the complete system is
communicating and has been configured
correctly, you can use identify mode.

Using identify from the
coordinator will show all products
that are connected to your system.

4

6

7

5

8

Maintenance

If replacing or adding iT600
devices please ensure you
follow steps 6 to 8.

Insert the adaptor into 230V mains outlet.

Press for 1

second

to activate

identify mode.

1

2

3

iT600 System

For PDF Installation guide please go to

www.salus-controls.com

CO10RF 003.qxd_Layout 1  18.06.2014  13:40  Strona 2

Отзывы: