Installation/Quick Start Guide
External Power Pack (ATVA408)
In the Box Tools Required
SAFETY INSTRUCTIONS:
Read these instructions carefully
before installing and using
the External
Power Pack and keep this guide in a safe place for future reference.
•
Verify compatibility
with the associated thermal radiator valve (TRV)
actuator before installation.
•
Make sure there is at least 1-inch (25.4mm) clearance between the
External Power Pack and the existing radiator, piping and radiator
housing.
•
Follow all applicable codes and regulations in the municipality where
this product is installed.
Salus accepts no responsibility for damage caused by not following these
instructions
INSTALLATION INSTRUCTIONS:
1.
Remove External Power Pack assembly
from the carton (exploded view).
2.
Remove the TRV battery door and 2 AA
batteries from the TRV housing.
3.
Slide the battery contact door out of the
External Power Pack housing.
4.
Insert the battery contact door into TRV
housing, snap into place.
5.
Slide the Power Pack housing over the
TRV until the clips snap into place.
6.
Position the assembly with 1-inch
clearance from any obstructions.
REMOVE AND REPLACE BATTERY:
1.
Unscrew the battery compartment cover
using a 2mm hex wrench and set aside.
2.
Remove the battery from Power Pack
housing.
3.
Insert new battery (type ER34615 only),
observing polarity.
4.
Replace battery compartment cover and
tighten hex screw.
The replacement battery MUST be
type ER34615 which is available
from several online resellers.
Observe battery polarity.
Caution! Do not short
circuit battery terminals.
Dispose of battery
responsibly.
External Power Pack for
Mini TRV (battery included)
Installation/
Quick-start Guide
2mm
Hex Wrench
TRV
TRV battery
door
Battery
contact
door
AA
batteries
Hex Wrench
Battery
compartment screw
Battery
contact door
Power Pack
locking clips
1” (25.4mm)
clearance
Battery
Negative (-)
terminal on
bottom
Battery
Cover
Battery
contact
door
Power
Pack
Housing
Battery
Battery compartment cover
Hold battery
compartment
cover closed to
relieve tension
on the screw
Hold battery
compartment
cover closed to
relieve tension
on the screw.
Do Not over-
tighten screw.
