Salus 091FLRF, Руководство пользователя, Страница: 6 / 30

4
GB
Multiple Thermostat Installations
Please note, if using more than one Receiver in the same
installation, be sure that there is at least a 1 metre gap
between receiver units to avoid RF interference.
When installing multiple thermostats you should ensure that you
assign different address codes for each Receiver following the ‘RF
Address Code Setting’ section of this manual. Each Receiver should
be introduced to the installation one at a time with all other receiver
units switched off, also make sure that the batteries are removed
from all other Control Centres.
Install each unit following the ‘TESTING THE RF TRANSMISSION’
section of this manual. Once you are happy with the operation of one
unit you may install the next. Once all Receiver ‘s are installed, if one
unit then seems to function abnormally, try changing the address code
of the control centre & its corresponding receiver again taking care
that the new code given is different to all others in the installation.
The control centre sends RF On/Off signals every 10 min to ensure
the receiver is in the correct state. If for some reason the 1st RF
signal is interrupted you may notice the control centre has started/
stopped calling for heat but the receiver hasn’t switched. Simply wait
10 minutes until the next RF signal is transmitted and the receiver
unit should switch.