Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
22
6 Maintenance and Troubleshooting
6.1 Maintenance
1. The high-precision DC motor used in SE3001 should be turned off to extend its service life when the SE3001 is
not used.
2. Do not touch the spinning blade by hands or other things. Otherwise, the blade will be damaged and deformed.
Beside, do not plug the blade in or off when the SE3001 powers on.
3. Do not block the fan on the rear panel when the SE3001 is running.
4. Please use the SE3001 in a dry and clean environment.
6.2 Cleaning
1. The SE3001 should only be cleaned with a soft cloth and mild soap detergent. Do not use a solvent-based
cleaner.
2. If the chopping blade need to be cleaned due to a dust-covered surface, please remove it from the chopping head
first, lay it on a clean platform, and then wipe it clean with a soft cloth. Besides, using a lubricating rust inhibitor to
wipe the blade can prevent it from rusting in a high humidity environment.
6.3 Troubleshooting
1. If the reference output frequency cannot lock to the setting frequency, please check whether choose the proper
blade type.
2. When in external reference mode:
a) If the screen shows “No Signal”, it indicates that the external signal is not correctly connected.
b) If the blade stops suddenly, please check whether the external reference frequency exceeds the available
range.
c) If the sync reference output goes wrong, please check whether the amplitude and frequency of the external
input signal are in available range.
3. If the blade stops spinning but all operations and settings are correct, please check whether the blade is blocked
by obstacles.
