Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
14
2. Double click “setup.exe” file and then install it in default settings.
Note that the PC needs to restart itself to finish the software configuration after the installation succeeds.
5.3 Installing Software
If all the former steps succeed, you can start installing the required software in the second file “Console_EN”. This
file includes the SE3001 application software which can run in Windows 8/7/XP environment.
1. Open the first file “Console_EN” and then double click the “Console_EN.exe”. If the former steps succeed, then
Fig.11 will occur.
Fig.11 Software interface
2. Configure the required parameters in the software window.
Note that if the PC has installed NI LabView 2011 or a higher version and a corresponding VISA driver, you can
skip chapter 5.2 and configure your SE3001 as the instructions in chapter 5.4.
5.4 Software Instructions
5.4.1 Connection between PC and SE3001
Before using the software to configure the SE3001, users should connect the PC and the SE3001 successfully.
1. Choose the right COM port at “COM configuration”, and then click “Connect” as Fig.12. If the connection
succeeds, the software will show the information of the machine.
