Tel: 886. 909 602 109 Email: [email protected]
www.salukitec.com
17
the PC will do these automatically online. You just need to wait for a few minutes. If the installation fails, you
need to install the driver manually according to Chapter 5.2.
3. Open the folder “ Uart Driver ” in your disk and double click the file UartAssist.exe. It will call out the
software interface, as is shown in Fig.15.
Fig.15 Serial debugging assistant interface
Note that this software can set the communication mode, the receiver mode, the transfer mode. The default Baud rate
of the SE3001 is 921600. The SE3001 has no parity bit, 8 data bits and 1 stop bit.
Choose “Fixed Byte Checksum” in appendix bits setting as is shown in Fig.16. The value of the fixed byte is 0DH.
The port number choose the COM number automatically assigned by the PC. Users can check it at the ‘COM and
LPT’ option in Device Manager of the PC, as is shown in Fig.17.
