4.
DO NOT
place next to any appliance that emits large amount of heat,
such as a dishwasher, microwave, oven, toaster, etc. or in direct sunlight.
Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption.
5. Extreme cold ambient temperatures may also cause the appliance not to
perform properly.
6. To help with door closure, position legs with a 1/8" (3 mm) tilt to the
back. Adjust the leveling legs by turning clockwise to raise and counter-
clockwise to lower.
7. Gently slide the racks into the unit.
Reversing the Door
Your Wine Cellar has been built to open from the right, however, it has been
designed to open from either side and can easily be changed by following the
procedure below. You will need a screwdriver and putty knife or other thin flat
device to remove the hinge covers. Use care to prevent scratching the surfaces.
1. Unplug the Wine Cellar from the wall outlet and empty, including
the shelves.
2. Remove the 2 top hinge covers and the screw hole cover on the door
and set aside.
3. Place protective padding behind the Wine Cellar. Turn the Wine Cellar
on its back onto the protective padding.
4. Remove the screws from the current hinges.
5. Transfer the hinges into the receptacle on the other side of the door,
and thread and secure the screws in their new location. Replace the hinge
covers appropriately.
HOW TO USE
Temperature Selection
1. Plug into a 120 volt outlet.
2. Allow the Wine Cellar to run for 24 hours on “Normal” before adding
wine bottles and making any temperature adjustments.
4
SAL7-578 Booklet Salton Wine Cooler WC-2036_EN V2.qxd 02/08/07 16:44 Page 4
