Recommend to use 50mm hose for connection, which should be certified according
to applicable ENstandard;
Regulator should be certified according to EN12864(from rate:max.1.5kg/h)
Warning:
●
read the instructions in the manual carefully, it has important information both for
operation use and for your safety.
●
do not use faulty appliances.
●
maintenance and repairs must be carried out by a qualified person only.
●
your heater should be checked manually by a qualified person for safe operation
and to detect any fault.
●
retain these instructions for future reference. If necessary, a new copy may be
obtained from your dealer.
●
turn off the gas container valve after use
●
the appliance is suitable for 14.2kg/5.5kg lpg container, when change gas container ,
move the appliance to a flamefree atmosphere.
●
do not move the appliance when in operation, avoid twisting the gas hose.
●
do not place the heater near walls, curtains or furniture while in
operation. Always face the heater towards the center of the room when
in use. Do not put furniture or other objects in front of the heater; minimum
clearance to combustibles to the rear and sides of the heater is 1000mm.
●
the dress guard on this appliance conforms to standard requirements; however
it does not provide full protection to individuals in close proximity of the heater.
the guard is to prevent risk of injury and no part of it should be removed or altered.
●
this appliance should be leakage tested before initial use and whenever
the cylinder has been reconnected after filling. Never use a naked flame to
test for leakage.
●
this is a nonflue heater. Ensure the room is ventilated while the heater is operational.
do not operate in a bedroom, bathroom, caravan, boat, or
any room less than 84cu.m in volume.
●
the guard on this appliance is to prevent risk of fire or injury from
burns and no part of it should be permanently removed.
●
this appliance requires a hose and regulator, check with your gas
supplier
●
do not use in leisure vehicles such as caravans and auto caravans
changing the cylinder:
turn off the regulator and disconnect the regulator from cylinder,
allow the heater to control fully before removing and replace the cylinder.
do not attempt to remove the regulator while the heater is still running.
Maintenance:
●
maintenance and cleaning must be carried out with the gas supply turned off
and the heater cold. Do not attempt to clean the heater while it is in use.
●
your heater should be checked annually by a qualified person for safe
operation and to detect any faults.
●
if any faults are detected in use, stop using the heater and contact your
dealer for advice.
●
periodically clean the exterior and rear cylinder storage area of your
heater, to remove dust and lint, which may affect operation of the
