4. Place the Kettle on the Base on a flat, level, dry, heat resistant
surface. Ensure that it is correctly engaged on the Base.
5. Plug into a 120V AC wall outlet.
NOTE: Never plug kettle into an electrical outlet when the kettle is
empty.
6. Direct kettle spout away from cabinets, walls, etc. to prevent possible
steam damage.
7. Depress the clear On/Off Switch below the handle and the red
indicator light will light up to indicate that the kettle is in the boil cycle.
Once the water has boiled, the On/Off Switch will move to the OFF
position and the light will go out.
IMPORTANT:
a) The kettle shuts off automatically after the boiling cycle is complete.
b) If the kettle is removed from the base before the boiling cycle is
complete the switch will move to the OFF position.
c) To turn the kettle off before the boiling cycle is complete, lift the
On/Off Switch to the OFF position.
8. The Lid should not be opened when the Kettle is hot.
9. If you want to use the Kettle again, allow the thermal safety switch
to cool down for 15 to 20 seconds then depress the On/Off Switch
to the ON position. If the On/Off Switch does not remain in the
ON position, the water is hot enough to use without reheating.
10.Unplug cord from wall outlet before lifting Kettle from Power Base.
Only grip the Kettle by the Handle as all other surfaces will be hot.
11.Return the Kettle to the Base or a heat resistant surface after use.
12.IMPORTANT: If the Kettle is accidently switched on when empty,
the thermostat will automatically cycle on and off to prevent the Kettle
from overheating. If this situation occurs, lift the On/Off switch to
the OFF (‘O’) position and unplug the Kettle immediately. Let the
Kettle cool before refilling.
13.It is recommended that the Power Cord be disconnected from the wall
outlet when not in use.
14.DO NOT attempt to connect any other appliance to the Power Base
or tamper with the connector in any way.
FILTER
Removing the Filter:
Locate the tab inside the spout on the top edge of the Filter. Press the
Filter Tab down to release the top edge of the Filter. Grasp the top edge
of the Filter on the inside of the kettle and lift the Filter up to release the
Filter Hook from the bottom edge of the spout.
4
