SYSTEM COMPONENTS
4
SETUP AND OPERATION
Follow these simple steps to prepare your SALTER AIRE
PLUS
®
Compressor for operation. The instructions below describe use with
a nebulizer. If an aerosol mask is to be used, follow the assembly
instructions that come with the mask.
NOTE
– Always wash your hands before you begin treatment.
NOTE
– Always have at least two Salter Labs nebulizers on-
hand available for use.
SETUP
1. Remove the compressor from its (optional) carrying case. Place
the compressor on a level, sturdy surface. Make sure you can
reach the controls when seated. Press the power switch to the off
position.
CAUTION
– Never block the air vents on the rear and bottom
of the device or place it where the vents may be blocked. Make
sure there is at least 15 cm (6 in) clearance on all sides of the
unit.
2. Plug the power cord into a power outlet.
3. Unpack the Salter Labs nebulizer and connect one end of the
tubing to the compressor’s outlet.
4. Assemble the nebulizer according to its instructions. Make sure
that the green cone has been placed into the nebulizer cup before
assembling the top to the cup.
CAUTION
– Do not use a nebulizer if its green cone is miss-
ing. Utilize a new nebulizer if necessary.
5. Add the prescribed liquid medication to the top of the nebulizer
using an eyedropper, premeasured unit dose, or ampoule.
6. Attach the mouthpiece to the nebulizer.
7. Connect the tubing to the bottom inlet on the nebulizer.
OPERATION
1. Press the power switch to the (on) position to start the com-
pressor.
5
Mouthpiece
NebuTech™
HDN™
Nebulizer
Docking
Port
Tubing
Air Inlet Filter
Flow Outlet
ON / OFF
Switch
Power Cord
•
