Salsco 810PTO, Руководство оператора и каталог запасных частей

Страница: 9 / 40

O:\Manuals\810PTO Chipper\810PTO Manual P.W. 10.30.2017.doc -9-
OPERATING INSTRUCTIONS
Count your extremities before you start!
Feet, hands, fingers, etc.
1. Read the manual again.
2. Look at the finger decal and study it. These could be yours!
3. Cut and install PTO shaft and cover as directed in this manual.
4. BE SURE all guards are in place before starting machine.
5. Set feed handle in reverse position (push towards machine).
6. Set direction of discharge chute and tighten in position.
7.
Be sure machine and tractor is on a dry, flat surface and it’s secured from rolling.
HINT: Be sure machine is not too close to the woodpile. You need room to work and
move around.
8. Bring tractor up to R.P.M. to give the PTO shaft 540 R.P.M.
9. Engage feed handle. NOTE: You will notice the more you pull the handle towards the rear of the
machine, the faster the roll turns and when you push in the other direction the roll slows down.
10. You are ready to chip wood, as soon as you put your safety glasses and gloves on and insert
earplugs.
11. Standing at the rear of the machine, looking at the hopper, feed the wood into the feed roll. Once the
machine begins, turn and walk away from the machine. It will draw the wood into without your
help. Go get another piece and repeat this procedure.
12. With large diameter pieces, it may be necessary to send in a smaller piece to start the feed roll. Also,
it may be necessary to monitor R.P.M. and back off on feed speed, (if you do not have the optional
Speed Sensing).
HINTS
1. When operating machine, stand off to the side of the feed hopper when feeding wood into the
machine.
NEVER STAND DIRECTLY IN FRONT OF THE FEED HOPPER WHEN
FEEDING WOOD INTO THE MACHINE.
2. When using the chipper and you have a short piece of wood bouncing around and not being
grabbed by the feed roll,
LEAVE IT! DO NOT TRY TO PUSH IT THROUGH WITH
ARMS OR LEGS! The next limb will push it through.
3. When through with the job let the machine clear itself completely, making sure all material is
through the machine before shutting it down. This will prevent injuries from flying debris when
the machine is started up at the next job.
4. COUNT YOUR EXTREMITIES AGAIN. BE SURE THIS NUMBER MATCHES YOUR
STARTING NUMBER.
WHILE PERFORMING MAINTENANCE OR REPAIR, ALWAYS DISCONNECT
THE PTO SHAFT FROM THE TRACTOR!