Salsco 413H, Руководство оператора и каталог запасных частей

Страница: 9 / 22

O:\Manuals\413..416.425MANUAL\413H_416B_425S_rev.10.30.17.doc
- 9 -
OPERATING INSTRUCTIONS
1) Be sure all guards and covers are in place.
2) Check all chambers to be sure they are free and clear of debris.
3) Set direction of discharge chute.
4) Start engine, bring up to full R.P.M.
6)
Begin feeding material into the machine. NOTE: You should be standing, looking at the
infeed hopper opening, as you place material into the machine. Turn to your left and exit the
area. Go and get another branch, do not worry about the chipper, it will take care of itself.
Should there be any wood left in the infeed, it will be taken care of by the next branch.
DO
NOT REACH INTO THIS MACHINE FOR ANY REASON!
7)
When you are done chipping, let the machine come down to an idle for a few minutes before
shutting down.
HINTS
1) When operating machine, stand off to the side of the feed hopper when feeding wood into
the machine.
NEVER STAND DIRECTLY IN FRONT OF THE FEED HOPPER
WHEN FEEDING WOOD INTO THE MACHINE.
2) When using the chipper and you have a short piece of wood bouncing around and not
being grabbed by the feed roll,
LEAVE IT! DO NOT TRY TO PUSH IT THROUGH
WITH ARMS OR LEGS! The next limb will push it through.
3) When through with the job, make sure all material is run through the machine before
shutting it down. This will prevent any injuries from flying debris when the machine is
started up at the next job.
REMEMBER! A CHIPPER WILL ONLY LET YOU MAKE A STUPID MISTAKE
ONCE!