salmson DIE, Инструкции по установке и запуску

Страница: 93 / 272

English
Installation and operating instructions SIE-DIE-PBE 87
BMS remote operation
5.2.3.0 Bus address Setting of bus address
5.2.4.0 IF-gateway val A
Specific settings of the IF-
Module, depends on protocol
type
Further information can be
found in the installation and
operating instructions of the
IF-Modules
5.2.5.0 IF-gateway val C
5.2.6.0 IF-gateway val E
5.2.7.0 IF-gateway val F
5.3.0.0 IN1 (sensor input) Settings for sensor input 1 Incl. all sub-menus, not dis-
played in manual control
mode
5.3.1.0 IN1 (sensor value
range) Display of sensor value range 1 Not displayed with PID con-
trol
5.3.2.0 IN1 (value range) Setting of the value range
Possible values: 0...10 V/ 2...10 V/
0...20 mA/ 4...20 mA
5.4.0.0 IN2 Setting for external setpoint
input 2
5.4.1.0 In2 active/inactive ON
External setpoint input 2 active
OFF
External setpoint input 2 inac-
tive
5.4.2.0 IN2 (value range) Setting of the value range
Possible values: 0...10 V/
2...10 V/ 0...20 mA/ 4...20 mA Not displayed when
In2 = inactive
5.5.0.0 PID parameters Settings for PID control Only displayed when PID
control is active
(incl. all sub-menus)
5.5.1.0 P parameter Setting of the proportional term
of the control
5.5.2.0 I parameter Setting of the integral term of
the control
5.5.3.0 D parameter Setting of the derivative term of
the control
5.6.0.0 Error Settings for behaviour in case of
error
5.6.1.0 HV/AC HV “heating” mode
AC “Cooling/air-conditioning”
operating mode:
5.6.2.0 Emergency opera-
tion speed Display of emergency operation
speed
5.6.3.0 Auto reset time Time until automatic acknowl-
edgement of an error
5.7.0.0 Other settings
5.7.1.0 Display orientation Display orientation
No. Designation Type Symbol Values/explanations Display conditions
±
±
±
±
±
±
±
±
±
±
±
±
±
±