Salicru ADVANCE 1000-HV, Руководство пользователя, установка и запуск

Страница: 20 / 40

- 20 -
5.- INSTALLATION.
5.1.- Inspecting the Equipment.
Inspect the UPS upon receipt. If the UPS has been damaged during shipment, keep the box and packing material for the
carrier. Notify the carrier and dealer immediately.
5.2.- Placement.
This UPS should be installed indoors with adequate airflow and free of contamination. Locate it in a clean and indoor
environment, free from moisture, flammable liquids, and direct sunlight. Maintain a minimum clearance of 4 inches (100mm);
an ambient temperature range must be 0°C to 40°C (32°F to 104°F), and operating humidity range must be 20% to 80%
relative humidity (non-condensing).
The long term uses at ambient temperature in higher than 25°C which should reduce battery life. In addition, place
the UPS unit away from the monitor at least 20cm. to avoid interference.
5.3.- Charging.
This UPS is shipped from the factory with its internal battery fully charged; however, some charge may be lost during shipping.
The battery should be recharged prior to use. Plug the UPS into an appropriate power supply and allow the UPS to charge at
least 4 hours.
5.3.1.- Load connection.
Connect one load-related device to each of the power receptacles supplied at the rear of the UPS.
5.4.- Modem/Phoneline Connection.
Plug incoming telephone line into the “In” socket at the back of the UPS. Use on telephone line cable and plug one end of the
telephone line cable to the “Out” socket at the back of the UPS. Plug the other end to the modem input socket.
5.5.- DC Start function.
DC Start Function enables UPS to be started up when AC utility power is not available and battery is full charged. Just simply
press the On/Off switch to turn on the UPS.
5.6.- Turn On/Off.
To turn on/off the UPS, you should press the on/off switch three seconds at least.