Smarty 4X P
www.salda.lt
* Drain (I-VIII) of the condensate is installed when the device is set in position b* or c* (shown in the illustrations above).
%HIRUHLQVWDOOLQJODWHUDOFRQGHQVDWHGUDLQDJHLWLVQHFHVVDU\WRUHPRYHDSODWH,,,LQDPHWDOSDUWRIWKHKRXVLQJDQGPDNHDKROH7KHFRYHU,VKRXOG
EHUHPRYHGDQGDEDWK,,FDSVVKRXOGEHUHPRYHGIURPWKHKROH&RQGHQVDWHGUDLQDJHPXVWEHLQVHUWHGLQWRWKHKROH,99XVHVLOLFRQJDVNHW9,
a washer should be placed from the other side and screwed using a nut (VII). Screw the nut by holding the pipe with a hand in order prevent spinning
(it’s possible to hold with a screwdriver or 1 Euro coin by putting it in the notch on the pipe). Screw the nut with a wrench (No. 27) until a top part presses
in the EPP casing (level with a surface or slightly enters into it).
Attention: Screwing force may not exceed 2 Nm.
Before every heating season the condensate tube shall be
¿OOHGZLWKZDWHUDVLQGLFDWHGGXULQJWKH¿UVWVWDUWXS%HIRUH
HYHU\ KHDWLQJ VHDVRQ WKH FRQGHQVDWH WXEH VKDOO EH ¿OOHG
ZLWKZDWHUDVLQGLFDWHGGXULQJWKH¿UVWVWDUWXS
Note.
,IWKHFROOHFWRULVVLWXDWHGXSVWUHDPLQVWDOODV\VWHPZLWKDFRQGHQVDWHSXPSRႇHUHGDVDQDFFHVVRU\
