Salda KF T120 Series, Монтаж и инструкция по установке

Страница: 13 / 20

EN | 13 KF T120_KF T120 EC v2019.04
a) The hose with “-“ must be connected before the fan. The hose with “+” measures atmospheric pressure.
Exhaust air Kitchen hood
+ -
SPS
+
-
IP44/54 1.5 A
CEE7/7
ModBus
CEE7/7
+ -
SPS
CEE7/7
ModBus
+ -
SPS
+
-
b) The hose with “-“ must be connected on the ducting before the fan. The hose with “+” must be connected after the fan.
+ -
SPS
+
-
IP44/54 1.5 A
CEE7/7
ModBus
CEE7/7
+ -
SPS
CEE7/7
ModBus
+ -
SPS
+
-
START-UP RECOMMENDATIONS
• The device can be started only by qualified and trained personnel.
• Before starting the device, make sure that the power chain matches the data on the label.
• Before starting the device, make sure that the device is connected to the power source in accordance with the scheme shown in this document
and under the electricity connection switch cap.
• Before starting the device, make sure that all the above listed security and installation instructions are arranged.
• When the device is started, make sure that the engine rotates evenly, does not vibrate and does not emit strange noise.
• Make sure, that there’s no foreign object in the fan before the launching.
• Make sure, that all the bolts and nuts are tightened before the launching.
MAINTENANCE
SAFETY REQUIREMENTS
• Installation works can only be performed by trained and qualified personnel.
• The device should be mounted firmly and rigidly so it’s safe use would be ensured.
• The device can be connected to pull the air from the air duct system
• It is necessary to ensure protection from contacting working fan impeller (for this, specially produced accessories or required air duct length is
used)
• Do not connect elbows close to the fan.
• When connecting the air ducts, pay attention to the air flow direction indicated on the device case.
• It is necessary to use grease filters which reduce the accumulation of dirt on the fan impeller. Accumulated dirt misbalances the impeller and
vibrations appear. This can cause engine failure.
• After the maintenance works and during the mounting back to the ducting, it’s necessary to perform the same steps as mentioned in the “Instal -
lation” and “Start-up” section and to comply with the requirements in this manual.
• Stainless steel drip tray for fats is designed for the drainage of fluids, what accumulates inside the casing.