P a g e
|
14
11-85-0000 VHF & UHF POCKET PAGING TRANSMITTER
Product Manual
Sea Air and land Communications Ltd, 10 Vanadium Place, Addington, Christchurch 8024, New Zealand
January 2018
Transmission Count:
How many times
that message will be sent if triggered.
Enabled:
When selected, the
configured message will be sent when
triggered.
Resend with Watchdog:
When the
watchdog is enabled, the action
message will be sent periodically as
configured if in the enabled state.
Use POCSAG Rapid:
Allows the use of
the “POCSAG Rapid” Salcom
proprietary shortened paging format,
used in conjunction with a Salcom
receiver.
Send While Held:
Sends and resends
the paging message for that action
repeatedly, without resending
message preamble, useful for
momentary relay control when used
with Salcom paging receivers.
PSD General Configuration
Selecting
Options->General
will display the general
configuration screen as shown. The following items may be
set here:
Baud Rate:
Changing this setting will result in all configured
messages to be sent at the selected baud rate (512 or 1200
Baud).
Input Debounce:
The time delay between the input being
triggered and the message being sent.
Invert Tx Data:
Internally generated data is inverted when
internal modulation is selected. The Invert Tx Data option is
unavailable when external modulation is selected.
Resend Delay:
When an action has been configured with a
transmission count greater than 1, then the resend delay is
the delay in seconds before sending the message again.
Frequency:
Configures the transmission frequency. Note that the selected frequency must be
evenly divisible by the channel spacing.
Channel Spacing:
Defines the frequency step resolution.
Sent Response:
Controls the serial response when a page has been transmitted.
