background image

!

!

A

B

1

 

Leveler Foot

Hex Nut

Washer

90

O

B

.

 

Connect Post   

             

 

 

Screw foot with metal washer 
through bottom shelf and 
onto       the end of an extruded 
post.     Hand tighten fully and 
use     wrench on hex nut to tighten         
nut onto underside of shelf. 

A

.

 

Square Post

             

 

 

Square the post to the bottom shelf.

 Connect Posts to Bottom Shelf     

                 

           

WARNING: 

Tighten by screwing the leveler foot NOT the post.

 

2

 

 Add Shelf Pegs  & Door Hinges  

                 

                  

B

B

A

A

B

.

 

Insert Hinges & Add Shelf Pegs 

             

 

                                 

Note: 

The door can be either left or right side opening. Select a side to open each door.

1.

 Hold door above the post and slide the bottom 

     hinge plate through the post channel.

2.

 Insert two shelf pegs. 

3.

 Slide top hinge plate through.

4. 

Gently tighten all remaining pegs with the 

     hex key to desired position.

A

.

 

Group Shelf Pegs     

           

 

                        

There are two varieties of shelf pegs (A and B). 
They are designed to cradle the shelf in place. 
Refer to drawing.

Doc No. 500-650/v11.12   

402 -2/4

Содержание SYNERGY 402

Страница 1: ...e for any damage to or destruction of other equipment conse quential to our equipment failure Defective product must be given Return Authorization and is to be returned to the factory prepaid in the original carton and packing material Any damage incurred in a shipment not in original packaging shall be the responsibility of the owner Warranty repairs will be returned prepaid via UPS within the co...

Страница 2: ... foot NOT the post 2 Add Shelf Pegs Door Hinges B B A A B Insert Hinges Add Shelf Pegs Note The door can be either left or right side opening Select a side to open each door 1 Hold door above the post and slide the bottom hinge plate through the post channel 2 Insert two shelf pegs 3 Slide top hinge plate through 4 Gently tighten all remaining pegs with the hex key to desired position A Group Shel...

Страница 3: ...learance Doors should be 1 8 above the bottom shelf before fully tightening hinges to post Use the wrench thickness as a guide for the bottom gap C Rubber Stops Attach the rubber stops to the inside of the door frame where it hits the shelf pegs when closing the door Attach Door Note The hinge can be separated by pulling the black tab and pulling apart the hinge from the hinge base Separated hinge...

Страница 4: ...of each post then position top studs through the small Rear Panel hole Repeat this step with the bottom studs aligning the Tool along the bottom of post to set spacing for cable passage Use the hex key to secure the top and bottom studs to the posts C Place Rear Panels Secure each panel in place with thumb nuts 1 2 3 4 5 6 7 8 9 S20 SVDO REAR PANEL 41 2 6 8 www salamanderdesigns com EXTENDED REAR ...

Отзывы: