Salamander Designs FPSA/MSB, Руководство по установке

Страница: 6 / 8

Surface Hub Battery Storage Case 501-738 v11.21 page 6 of 8
3.
Bracket Alignment
Attach the Storage Case by inserting the support tabs into the two slots ensuring that the
two L Brackets fall inside of the Storage Case.
Gently push the Storage Case down until the support tabs are seated in the slots.
Secure the Storage Case by installing the two 10-32 x 3/8” button head cap screws through
the support tabs and into the L Brackets.
Tighten the L Bracket screws that were installed in the previous step.
Remove the Storage Case by removing the 10-32 x 3/8” button head cap screws.
4.
Secure Battery
Install the battery to the Storage Case using the four 1/4-20 x 1/2” Button Head Cap Screws and
Bonded Washers as shown. Ensure the Bonded Washers are installed with the rubber side down.
Ensure that the battery is installed in the orientation shown, with the AC OUT and DC OUT ports at
the top of the Storage Case.
BACKPACK TOP
STORAGE CASE
1/4-20 x 1/2” BUTTON HEAD
SOCKET CAP SCREW (2x)
BONDED WASHER (4x)
10-32 x 3/8” BUTTON HEAD
SOCKET CAP SCREW (2x)