Salamander XL Electric Lift Mobile Stand Designed for Cisco Webex Board Pro 75”
501-659 [6.22] page 4 of 24
Duty Cycle of the motor control system:
The duty cycle is 10% ~ 6 min./ hour or max. 2 min. of continuous use, irrespective of the load.
This must NOT be exceeded as this will result in a superheating of the motor. Exceeding the duty cycle will result in a
dramatic reduction of the life of the system.
The motor control system range contains the following components:
• 1 control box
• 2 or 3 Telescoping actuators
• 1 exchangeable main power cable
• 2 or 3 motor cables
• 1 Wired remote control
Troubleshooting / Initialization of the motor control system
If motor control system malfunctions follow these steps;
The system is initialized by pressing the down button once or twice and holding it down until unit runs into end stop, it will
then automatically run approx. 3 mm out again and hereafter slowly running in again. Only release the down button when
the movement has completely stopped. If the key is released before the sequence is completed then the initialization is
interrupted and must be started again from the beginning. It is sometimes necessary to press the down button twice to start
the initialization this is because the system can be in different modes when the initialization starts.
WARNING: Risk of Electric Shock – Connect the device to a properly grounded outlet only. Do not defeat the safety
purpose of the polarized or grounding-type plug. A polarized plug has two blades with one wider than the other. A
grounding type plug has two blades and a third grounding prong.
The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an
electrician for replacement of the obsolete outlet. Do not use a plug adapter that defeats the ground pin of the AC plug.
SERVICING OF DOUBLE-INSULATED PRODUCTS: In a double-insulated product, two systems of insulation are provided
instead of grounding. No grounding means is provided on a double-insulated product,nor is a means for grounding to be
added to the product. Servicing a double-insulated product requires extreme care and knowledge of the system, and is
to be done only by qualified service personnel. Replacement parts for a double-insulated product must be identical to the
parts they replace.
WARNING: Do not overload the wall outlet where this device is being connected. Do not overload this device. Ensure the
total load to this device does not exceed that which is listed in the specifications section of this manual.
Maintenance
• DANGER – To reduce the risk of electrical shock: Always unplug this device from the electrical outlet before cleaning.
• Clean dust and dirt with a dry cloth, on the outside of the system at appropriate intervals and inspect for damage.
• Inspect the connections, cables, and plugs and check for correct functioning as well as video monitor fixing points.
• When furnishing is not in use, cords should be unplugged and bound with a wire manger, such as a velcor strap, cable
tie or the a like.
• Furnishing should be stored in a dry indoor environment.
Repairs
• Refer all servicing to qualified service personnel. Servicing is required when the device has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the device, the
device has been exposed to rain or moisture, does not operate normally, or has been dropped.
• There are no user-serviceable components within this device. Removal of the cover from this device may present a
shock hazard, and void the warranty.
***** SAVE THESE INSTRUCTIONS
*****
Accessories and Spare Parts
Please contact your nearest Salamander Designs dealer or www.salamandercommercial.com
