SAKAWA AS15TE, Руководство пользователя

Страница: 80 / 85

80
CAUTION: ACCUMULATED FIREWOOD AND WOOD CHIPS ARE SOURCES OF DANGER.
ALWAYS KEEP YOUR AREA AROUND YOU CLEAN SO YOU CAN'T SLIP.
PRECAUTION:
- Always disconnect the power supply from your machine before you start releasing any stuck
logs.
- Don't let other people help you free a stuck log.
- To release a stuck log, never hit your chipper with blunt objects. Do not mistreat the stuck log
with your feet or any object either, as a sudden release of the stuck piece will cause the log pusher
to give way. It can lead to personal injury or damage to your machine, respectively.
- All safety rules contained in the chapter "General Safety Instructions" shall apply to any of the
interventions described above. The manufacturer shall not be liable for any injury to persons or
animals or damage to property as a result of improper use of this machine or failure to comply
with the
safety standards.
Application
IMPORTANT: There is a breath plug on the left side of the machine. Every time you want to start
your work, you need to loosen this plug about four turns to ensure good air circulation in the oil
tank. Before transporting this machine, close this cap to prevent oil leakage. If you leave the vent
plug tight while working, hydraulic movements will cause an overpressure that can damage your
machine.
1. To ensure a longer life of your machine, apply a little grease to the sliding surfaces always after
use (cleaning the area beforehand).
2. Always place the power cord so that it cannot be damaged (by your work).
3. Open the vent plug. Open the hydraulic oil tank cap for a few turns each time you start your
work. Completely close the lid of the hydraulic oil tank after work.
4. Check the operating direction of the engine.
CAUTION: NEVER RUN THE ENGINE IN THE WRONG DIRECTION. THIS WILL INEVITABLY
LEAD TO DAMAGE TO THE PUMPING SYSTEM, AS A RESULT OF WHICH YOU WILL NO
LONGER BE ENTITLED TO CLAIM UNDER WARRANTY.
5. If you want to run this log splitter at very low temperatures, run the machine at rest for 15
minutes before starting work to allow the hydraulic oil to warm up.
5. If necessary and in order to reduce the risks of accident, immediately remove the cut wood
from your work area and stack it.
5. After you have finished your work, allow the cutting blade to return to its starting position. Then
stop the engine and disconnect the machine from its power supply and let the machine cool down.
After that, you need to clean and lubricate it. This log splitter can only be stored in a dry and clean
place. Make sure the oil tank has the lid tightly closed and no oil will come out during storage.
CAUTION: ACCUMULATED FIREWOOD AND WOOD CHIPS ARE SOURCES OF DANGER.
ALWAYS KEEP YOUR AREA AROUND YOU CLEAN SO YOU CAN'T SLIP.
PRECAUTION:
- Always disconnect the power supply from your machine before you start releasing any stuck
logs.
- Don't let other people help you free a stuck log.