- 2 -
Section Two
-
Lithium Battery
Before using your camera for the first time, charge your camera’s battery. Once the
battery is charged, move the Camera/Charger selector to “Camera” mode. Do not
move the selector back to “Charge” mode until you have downloaded all your
photos to your computer and are ready to recharge the camera.
Switching to
Charge mode will erase all the photos on your camera
.
To recharge your camera’s battery, connect the camera to your computer with the USB
cable and move the Camera/Charger selector to “Charge” mode. When the batteries
are recharging, the LED will be red. Once the batteries are fully charged, the LED will
turn green (after less than 3hours). The camera will function normally while charging.
We recommend charging your camera’s battery every 7 days or when you have used
up the full memory capacity of the camera.
NOTE: The camera batteries must be recharged for at least four hours on the
first use.
In order to conserve battery power, if the camera is not used for 30 seconds, the
camera will automatically enter energy save mode.
Section Three – Software and Camera Driver Installation
IMPORTANT: Before attempting to install the software, ensure that you do not have
the camera attached to your computer. This will affect the installation process and
could cause your installation to fail. Do not connect the cable to the computer until
the entire installation process has been completed. We recommend
following
the step by step instructions that will appear on your screen during the installation
process.
1.
Insert the CD into your CD-Rom drive. Make sure that your camera
is
not
connected to the computer.
