HS2/AS2 Series
3
4
PREPARATION
2.1 Safety Instructions
For safety, be sure to read all the safety instructions carefully prior to any works, and please observe the
appropriate rules and regulations of the country or region where you installed all-in-one energy storage
system.
DANGER
· There is possibility of dying due to electrical shock and high voltage.
· Do not touch the op
erating component of the inverter; it might result in burning or death.
· To prevent risk of electric shock during installation and maintenance, please make sure that all AC and DC terminals
are plugged out.
· Do not touch the surface of the
equipment while the housing is wet, otherwise, it might cause electrical shock.
· Do not stay close to the
equipment while there are severe weather conditions including storm, lighting, etc.
· Before opening the housing, the SAJ inverter must be disconnected from the gr
id and PV generator; you must wait
for at least five minutes to let the energy storage capacitors completely discharged after disconnecting from power
source.
·Please keep the power off prior to any operations
·Do not expose the battery to temperatures in
excess of 50
°C.
·Do not subject the battery to any strong force.
·Keep inflammable and explosive dangerous items or flames away from the battery.
·Do not soak the battery in water or expose it to moisture or liquids.
·Do not use the battery in areas where
the ammonia content of the air exceeds 20ppm.
WARNING
·Only qualified personnel who has full knowledge of local safety regulations and local standards on battery can install, main
tain,
retrieve and process this product.
·SAJ electric shall not b
e liable for any loss or warranty claims arising from any unauthorized change of product which may cause
fatal injury to the operator, third party or equipment performance.
·For personal and property safety, do not short
-circuit the positive (+) and negative (-) electrode terminals.
CAUTION
·Risk of damage due to improper modification
·Use professional tools when operating the products.
· The inverter will become hot during operation. Please do not touch the heat sink or peripheral surface during or
shortly after operation.
NOTICE
2.
