Saivod CT 1830D NF, Инструкция по эксплуатации

Страница: 7 / 39

2
Transport instructions
The appliance should be transported only in
upright position.
Before the performance of the working test in the
shop, the packing of the appliance must be intact.
After a transport in the horizontal position, the
device may only be taken into operation 4 hours
after being stood up vertically again.
The appliance must be protected against rain,
moisture and other atmospheric influences.
The manufacturer assumes no liability if safety
instructions are disregarded.
Disposal
Make the device unusable immediately.
Pull out the mains plug and cut the power cable.
Remove or destroy snap or latch locks
before disposing of the device. In this
manner you prevent children from locking
themselves in and endangering their lives.
Device setup
•
Do not operate your appliance in a room where
the temperature is likely to fall below
10°C at night and/or especially in winter. At lower
temperatures the appliance may not operate,
resulting in a reduction in the storage life of the
food.
•
The climate class rate of your appliance is given
in Technical Features leaflet and written on the
rating label inside the appliance. It specifies the
appropriate operating ambient temperatures as
explained below.
Climatic class Ambient temperatures
SN........................... +10 °C to 32 °C
N ............................ +16 °C to 32 °C
ST .......................... +18 °C to 38 °C
T.............................. +18 °C to 43 °C
SN-ST..................... +10 °C to 38 °C
SN-T ...................... +10 °C to 43 °C
Location
Only place the appliance, as shown in the
illustration in dry rooms which can be aired.
Avoid direct sunlight or direct heat sources such
as a stove or a heater.
If this cannot be avoided, the following minimum
distances should be maintained:
Electric stoves: 3,00 cm
Heater: 3,00 cm
Cooling devices: 2,50 cm
• Ensure sufficient air circulation for your device.
• Make sure that sufficient room is provided
around the appliance to ensure free air circulation
(Item 3).
Fit the two plastic wall spacers supplied with
the appliance rotating 1/4 turn to the condenser at
the back of the appliance (Item 4).
• The appliance should be located on a smooth
surface. The two front feet can be adjusted as
required (Item 5). To ensure that your appliance is
standing upright adjust the two front feet by turning
clockwise or counter-clockwise, until the product is in
firm contact with the floor.
Correct adjustment of feet avoids excessive
vibration and noise.
Electrical connections
Warning
This appliance must be grounded.
• Check whether the power type and voltage in
your region corresponds to the one stated on the
rating label inside the appliance.
• The electrical safety of the appliance is only
assured when the grounding system in the house is
installed in accordance with regulations.
• When placing the appliance, do not let the power
cable get stuck under it; otherwise the cable will
be damaged.
• Ensure that the plug remains readily accessible.
Do not use a multiple adapter bar or an extension
cable.
GB
Instruction for use