INSTALLATION FOR USERS OF WINDOWS® 2000
A) Drivers Only For Typical Users
1
With your computer switched on, close down any programs that are currently running and
insert the Saitek Smart Technology CD into your CD-ROM drive.
2
When the Introduction Screen appears, click
Install Software
to continue.
3
When the
Welcome
screen appears, click
Next
to continue. (If the CD does not run
automatically, select
Start
from the Windows® Taskbar, then
Run
and type
D:\Setup.exe
and
click OK - where
D:\
is letter of your CD-ROM drive).
4
After reading the Disclaimer, select the
I accept the terms of the Disclaimer
option and click
Next to continue.
5
At the
Device Driver Installation
screen, click on
Next
and follow the on-screen instructions.
6
When prompted, plug your controller’s USB connector into your computer, then click on
Configure
.
7
When the
Controller Properties
screen appears, click
Next
to view the
Test
screen.
8
Now try out all your controller’s buttons and controls to show that it is working properly. When
you have finished, click
OK
.
9
At the
Programming Software
screen, select
Typical User
and click
Next
.
10 At the
Registration screen
, select
Register
and follow the on-screen instructions or select
Register Later
and click
Next
.
11
Click on
Finish
to complete the installation.
B) Drivers and Programming Software For Advanced Users
1
Follow points 1 – 7 of the install procedure in
A)
, then at the
Programming Software
screen,
select
Advanced User
and click
Next
.
2
At the
Programmable Controller Drivers
screen, click
Update
and follow the on-screen
instructions.
3
Then at the
Installation of programming software successful
screen, click
Next
.
4
At the
Registration
screen, select
Register
and follow the on-screen instructions or select
Register Later
and click
Next
.
5
Upon completion of the installation, you have the option to
Run Profile Editor
, which will give
you a view of the 3D programming environment. If you do not wish to see the Profile Editor at
this point, just uncheck the box and click on
Finish
to complete the installation.
P3000 Micro RoW Manual.qxd 30/01/2004 08:50 Page 5
