13
3.8 Guide-a-cut assembly
Angle guide-a-cut
Secure the materials stop on the table.
Insert the guide-a-cut in the materials stop on
the table
Set the guide in the desired position before
tightening the screws
Lateral guide-a-cut
Put the guide-a-cut on the table
Slightly tighten the two knobs.
Slide the guide-a-cut to the proper distance
from the cutting line.
Strongly tighten the two knobs.
3.9 Water cooling system
Fill the water pan with clean water to 1cm of the edge of the water tray.
Ensure that water is delivered adequately to the blade, as insufficient water supply may result in
premature failure of the diamond blade.
The water pump must never run without water. Always make sure that there is enough water in
the pan and refill if necessary.
In case of frost, empty the water cooling system from its water.
3.10 Starting the machine
Connect the machine to the electrical supply. You can start it pressing the green button on the
switch. To stop the machine, press the red button. The red button is also the emergency switch.
