SainSmart Genmitsu 4040-PRO CNC Router, Руководство пользователя

Страница: 10 / 106

08
Step 2: Installing the MDF Spoilboard
What you will need
1. Following the diagram below, align the holes of the MDF spoilboard with the screw holes in the front and rear module,
with the recesses at the top, then loosely screw into place with the (12) M5*20 screws.
(DO NOT TIGHTEN ALL THE WAY, allow for small movement between the MDF spoilboard and the front and rear
module until later.)
2. As shown in the diagram, insert 8 of the locating pins into the corresponding holes on the front and rear modules
respectively. (When inserting the locating pins in the rear module, take care to avoid the wire in its middle square hole to
avoid any damage to the wire)
(2) MDF Board
7
Allen Wrench Set (4mm)
13 (8) Locating Pin
9
(12) M5*20mm Bolt
10
Locating Pins
Locating Pins
Locating Pins
Locating Pins
(12) M5*20mm Bolt
Cable
Locating Pin