Table 1
5. Insert two AAA batteries.
6. After inserting the batteries, the remote sensor LED indicator will
light for 4 seconds, and then flash once per 60 seconds thereafter.
Each time it flashes, the sensor is transmitting data.
7. Verify the correct channel number (CH) and temperature units of
measure (°F vs. °C) are on the display, as shown in
Figure 3
.
(1) temperature
(2) temperature units (°F vs. °C)
(3) channel number
(4) relative humidity
Figure 3
8. Close the battery door. Make sure the gasket (around the battery
compartment) is properly seated in its trace prior to closing the door.
Tighten the set screw.
DIP SWITCH
FUNCTION
Channel 1
Channel 2
Channel 3
Channel 4
Channel 5
Channel 6
Channel 7
Channel 8
°F
°C
1
2
3
4
-20-
