17 |
Sailritecom
Leatherwork
®
Assembly Instructions
| 18
Changing Motor Rotation
Plug the motor in and turn it on The standby
screen will show a “P” with a rotating dash
(
33
)
With the Posi-Pin disengaged
(p 14,
M
)
operate
the machine and make sure the motor runs in a
counterclockwise direction (
A
)
If the balance wheel is spinning the opposite
direction from
(
32
)
, follow the instructions below
to reverse the direction
1 Press the “P” button four times until the
LED display reads “n3”
2 Press the “S” button multiple times to
select between “0” and “1”
3 Select “1” and the motor will run clockwise
4 Select “0” and the motor will run
counterclockwise (this is the setting the
motor should be on)
5 Press the “P” button to save the selection
of “0”
6 Turn motor off then on
A
Install Light & Wire
Plug light into included extension cord (
F
) To
attach the LED light (
G
), place the magnetic
light in your desired location
Note:
If it is a 110 volt sewing machine, the light
will plug into the back of the Workhorse
®
Servo
Motor If it is a 220-240 volt machine, the light
will plug into a wall outlet
Use the included adhesive pieces and wire
ties (
H
) to secure the light cord in your desired
locations Make sure to keep the cord out of the
way of any moving machine parts
Insert Thread Stand Posts
Locate the thread stand posts (
B
,
C
and
D
) The
longest post with looped end (
E
) will drop into
the back corner hole on the tabletop Gently
tap the non-tapered end of the short post (
C
) in
the tabletop corner hole just in front of the taller
post The thread post with holes in it (
D
) gets
screwed into the top of the machine
(
35
)
E
H
G
B
C
D
32
33
34
35
F
Содержание Leatherwork 3008-00
Страница 1: ......